Sep 23,2022

　　All the main key parts of the semi-automatic capsule filling machine, such as drive shafts, cams, bearings, etc., are all imported materials. A semi-automatic capsule filling machine is a new type of pharmaceutical packaging machinery, with a novel structure and beautiful appearance. And other actions, instead of a manual filling, reduce labor intensity, improve production efficiency, and accurate filling doses, in line with pharmaceutical hygiene requirements.

　　The function of this mechanism is to automatically put the medicinal materials into the empty capsule in the capsule mold in sequence, and the bucket is equipped with a step-less speed regulating motor (the instrument displays the speed), which drives the propeller to force the medicinal materials into the empty capsule. After the support of the filling rod of the capsule filling machine is in a low position, loosen the locking screw of the gripper, and rotate the adjusting bolt to make the lower end surface of the filling rod and the upper surface of the dosing plate on the same plane.

　　Semi-automatic capsule equipment machine function

　　1. It adopts a fully sealed structure and conforms to GMP standards;

　　2. Variable frequency drive, stable and reliable operation;

　　3. The filling powder tray is large and the filling capacity is large;

　　4. The main drive bearing seat is a detachable structure, which is convenient for installation and maintenance;

　　5. Sheave mechanism, indexing, long service life;

　　6. Adopt Japan's Mitsubishi variable frequency drive, step-less speed regulation.

　　The mechanism is equipped with automatic counting control. When the mold is full of capsules, the mechanism will automatically stop, and it can also be manually stopped when it needs to stop in the middle. The speed of the machine is adjusted with the inverter knob and button on the console and is equipped with an instrument to display the speed. However, it is worth noting that the machine should be checked before starting the machine, and the main motor shaft wheel should be turned by hand to make the machine run for 1-3 cycles. It needs to be observed when the vacuum is not turned on), if it cannot fall freely, the position of the dispensing part of the capsule shell needs to be adjusted until it meets the requirements.

　　Our HG-1000A capsule equipment machine can handle all capsule sizes from 000 to 5. The special design allows easy, simple, and accurate change of capsules of different sizes within 15 minutes. Powder, granular or granular materials can be filled. Capsulcn Labs tested it with no failures for 600,000 minutes.